MTSs Temp Control for InfuSsion Mash Tun
The MTSs is designed for use with Ss Brewtech’s Infusion Mash Tun. During extended Mash periods or in relatively cold ambient temperatures, the mash will naturally drop in temperature. With the MTSs you will be able to provide better controlled temperatures during the mash scarification process. Holding a consistent scarification temperature will insure you are making the beer and flavor profiles you planned to produce. The MTSs is a low wattage silicone heater pad, which is bonded to the underside of the 5 degree sloped bottom on your Mash Tun using a strong adhesive backing on the heater pad. The heater is controlled with a 12 volt digital temp controller. You simply set your target temperature and the heater will cycle on and of to maintain your set point. This system is NOT designed for heating water to strike temp and/or step mashing, though it can help with fine tuning your strike water temp those last few degrees and/or maintaining your strike water temp while you are preparing your grist or balancing your water chemistry.
MTSs Temp Control for InfuSsion Mash Tun MTSs Temp Control for InfuSsion Mash Tun SS Brewing Technologies MTSs Temp Control for InfuSsion Mash Tun SS Brewing Technologies

MTSs Temp Control for InfuSsion Mash Tun

  • Mash Temperature Stabilization System
  • Keep your mash temperature stable 
  • Holds mash temp to within 1 degree of set point
  • Use to make kettle sours - click HERE
  • 12V adhesive heater pad 
  • 5A 12V Power supply (bigger than FTSs)
  • Digital temp controller
  • Grommet / zip tie (for strain relief)
  • NOT intended to rapidly increase temps
  • NOT intended take room temp to strike temp
  • ONLY for Ss Brewtech InfuSsion Mash Tun
  • Click HERE for Quick Reference Guide
  • Click HERE for a homebrewtalk.com review

Type: Accessories


Image tab for Frequently Asked Questions